Torsion Axle, 3,750 lb Capacity, 74" Frame Center, 91.25” Hub Face, 80” Outside Bracket, 25* Down Angle, Galvanized, Load Rite OEM Axle, Alt Part #46385A
SKU: 4271.44
Load Rite Tie Down Eliminator Galvanized 3700# Axle with Removable Spindles, Torsion Arms Set at a 25 degree Starting Angle.
SuperLube Lubrication
This Axle's Spindle is equipped with TDE’s SuperLube Lubrication System. The bearings can be periodically lubricated without removing the hubs from the axle. The advantage to this system is that new grease saturates the inner bearing and outer bearing while pushing out the old grease, unlike systems that just push new grease on top of old grease.
1. Remove the rubber plug from the grease (hub) cap.
2. Use a standard grease gun onto the grease fitting located at the end of the spindle, making sure the grease gun nozzle is engaged on the fitting tightly.
3. Pump grease into the fitting, while slowly turning the wheel. Grease will flow out of the hub around the spindle.
4. When the grease appears to be the new clean grease, remove the grease gun and wipe off any excess grease.
5. Replace the rubber plug in the cap.
All Dexter/Tie Down Axles are proudly made in the USA!
With 5 Lug Pre - Greased Hubs Installed
Axle Type: Torsion
Weight Capacity: 3,750 lbs
Hub Face: 91.25"
Frame Center: 74"
Outside Bracket: 80"
Starting Angle: 25*
Spindle Size: 1-3/8" x 1-1/16"
Finish/Material: Galvanized
Includes Brake Flange: Yes
Removeable Spindles or Trail Arm:
Includes Hubs: Yes. 5 x 4.5" Idler hubs
Brand/Manufacturer: Load Rite OEM Axle Manufactured by Dexter
Alternate Part #: 46385A
Used on Load Rite full frame 102" Trailers (prior to 2019)
See attached schematic for specsSuperLube Lubrication
This Axle's Spindle is equipped with TDE’s SuperLube Lubrication System. The bearings can be periodically lubricated without removing the hubs from the axle. The advantage to this system is that new grease saturates the inner bearing and outer bearing while pushing out the old grease, unlike systems that just push new grease on top of old grease.
1. Remove the rubber plug from the grease (hub) cap.
2. Use a standard grease gun onto the grease fitting located at the end of the spindle, making sure the grease gun nozzle is engaged on the fitting tightly.
3. Pump grease into the fitting, while slowly turning the wheel. Grease will flow out of the hub around the spindle.
4. When the grease appears to be the new clean grease, remove the grease gun and wipe off any excess grease.
5. Replace the rubber plug in the cap.
All Dexter/Tie Down Axles are proudly made in the USA!